Package Avs-FirmwaresBundle_26.01.23

• AVBx3 version: 5.008

• Fix: No more change of clock configuration when configuration change detected.

• AiC-CORE-X-A7-FPGA version: 2.033

• Improve internal data bus to avoid useless events on some writes actions
• Improve event feedback on the Signal Generator for the graphic interface

• AiC-CORE-X-A7-FPGA-TDISPLAY versions: 2.033 / 1.023

• Improve internal data bus to avoid useless events on some writes actions
• Improve event feedback on the Signal Generator for the graphic interface
• Add screen lock interface
• Fix rename card display

• AiC-xCore version: 2.053

• Improve internal data bus to avoid useless events on some writes actions
• Improve event feedback on the Signal Generator for the graphic interface

• AVBx7 version: 4.064

• Last changes since version 4.51
• Fix: Restore mute, ramp mute, card user in/out number in card parameter mode scene save mode. With matrix scene save mode parameters card user in/out number are also restored.
• Fix: DDR rewrite setting only on change. Add QOS DDR change register.
• Fix: Wait end of FPPR command before sending command to next CPU
• Fix: Flash save error in some case.
• New: Add QOS FPPR answer timing.
• Fix: Increase FPPR save parameter timeout up to 4000ms.
• Fix: Command "revert to factory settings" on a single slot was applied to slot and Xcore.
• Fix: Mailbox answer XCore during intialisation state.

• AxC-GPIO-Wclk version: 2.003

• Changes from version 2.000:
• - Changed GPIO struct to comply with new mapping of registers between 0x0E-0x13
• - Increment the level of each Interrupt (i.e. decrement all priority interrupts)
• - Replaced NVIC_SystemReset by AxC_Flash_Cmd_Reset() that restart 1st Boot...to bypass potential issue with new LPC1114
• - Low level modification of SSP interrupt handler to bypass transmission of bad value when TX Fifo is empty
• - Fix wrong reads value of the GPIO/WCLK from AVSMonitor during flash erasing and writing
• - Version Compiled with MCUXpresso
• - Added name page registers

• ALP-AES67-A7 versions: 1.195 / 4.012

• Add multi redundancy mode : none , redundante , NMOS OOB
• Fix UPI8 WideMode.

• ALP-DANTE-A7 versions: 1.195 / 11.048

• New : Change redundancy configuration from application.
• Fix UPI8 WideMode.

• AVDT-BOB-AE4IO versions: 3.029 / 1.005

• Fix: Embedded web service

• AVW-DT4I versions: 2.131 / 5.007

• Fix: Reduce WHO delay up to 7ms?
• Fix: Improve DT4oB audio quality of Bluetooth for new bluetooth module

• AxC-ADSP versions: 2.021 / 2.044

• New: Handle UPI8 wide memory mode.
• New: Handle UPI8 FPPR access.
• New: Creation of memory area for encryption keys.
• New: Update webService.
• Fix: Memory free errors.
• Fix: TCP ACK timeout was too short wait now at leat 25ms, before resend tcp data.

• AxC-AES67-A7 versions: 2.012 / 4.012

• Add multi redundancy mode : none , redundante , NMOS OOB.
• Fix UPI8 WideMode.

• AxC-AT32IO version: 4.018

• Change some internal I/O number registers to read-only
• DMA page is no longer loaded (when exists) to avoid rare cases of undesired registers writes at load
• Fix some rare cases of internal processor freezing, leading to a potential non-working device

• AxC-AVB versions: 2.103 / 2.044 / 8.096

• New: Support FPPR command UPI8
• Fix: Milan Manager/clock loop if multiple cards are in the same AVBx.
• Fix: Clock publication if multiple cards are in the same AVBx (Hive AEM Error).
• Fix: Corruption of internal AVB channel routing in R_PAAD mode .
• Fix: Incorrect passing UPI8 wide mode. Resulting in some view and controls to be limited in GUI.

• AxC-AE8M version: 2.026

• Change some internal I/O number registers to read-only
• DMA page is no longer loaded (when exists) to avoid rare cases of undesired registers writes at load
• Fix some rare cases of internal processor freezing, leading to a potential non-working device

• AxC-AS16MO-V2 version: 1.025

• Change some internal I/O number registers to read-only
• DMA page is no longer loaded (when exists) to avoid rare cases of undesired registers writes at load
• New version of internal communication bus
• Fix some rare cases of internal processor freezing, leading to a potential non-working device

• AxC-AX4M version: 4.028

• Change some internal I/O number registers to read-only
• DMA page is no longer loaded (when exists) to avoid rare cases of undesired registers writes at load
• Fix some rare cases of internal processor freezing, leading to a potential non-working device

• AxC-AX4I version: 7.026

• Change some internal I/O number registers to read-only
• DMA page is no longer loaded (when exists) to avoid rare cases of undesired registers writes at load
• Fix some rare cases of internal processor freezing, leading to a potential non-working device

• AxC-CN32IO version: 2.023

• Change some internal I/O number registers to read-only
• DMA page is no longer loaded (when exists) to avoid rare cases of undesired registers writes at load
• Fix some rare cases of internal processor freezing, leading to a potential non-working device

• AxC-DANTE versions: 2.063 / 11.048

• New : Change redundancy configuration from application.
• Fix UPI8 WideMode.

• AxC-DANTE-A7 versions: 1.025 / 11.048

• New : Change redundancy configuration from application.
• Fix UPI8 WideMode.

• AxC-DX8I version: 6.034

• Change some internal I/O number registers to read-only
• DMA page is no longer loaded (when exists) to avoid rare cases of undesired registers writes at load
• Fix some rare cases of internal processor freezing, leading to a potential non-working device

• AxC-ES100 version: 3.008

• Bug fix on PID that could disable the ASIO capability

• AxC-GPIO16 version: 2.005

• Changes since version 2.003:
• - Rajout des CNAPR
• - Modification du cycle de gestion des GPIO de 50ms à 1ms

• AxC-MADI versions: 12.029 / 3.008

• Fix: Flash save failed due do overwriting lock fppr bit.
• Fix: Incorrect passing UPI8 wide mode. Resulting in some view and controls to be limited in GUI.

• AxC-MADI_SFP versions: 12.029 / 3.008

• Fix: Flash save failed due do overwriting lock fppr bit.
• Fix: Incorrect passing UPI8 wide mode. Resulting in some view and controls to be limited in GUI.

• AxC-SWD5G version: 1.010